Windsor Estate Gates
- Brand: BIC
- Product Code: BIC520
- Availability: In Stock
The Windsor Estate Gates are an exquisite pair of solid wooden gates, with thick frames and bracing accompanied with a gothic metal pattern insert, all excellent for providing a strong and secure barrier to your property. As one of our premium designs, the Windsor Estate Gates offer a grand entrance that would complement even the most stately homes.
The gates are hand made in the UK and feature an open top section that is filled with the elegant gothic metal design which helps make this range so popular! The lower section is solid tongue and groove, framed on both sides and across the top. The timber is smooth planed Scandinavian Redwood which has been pressure treated for a long, maintenance free life. Each gothic pattern insert has been electro-galvanised and black powder coated to give a smooth, high quality finish which will be maintenance free for 5 to 10 years. A top coat of metal preservative paint (such as Hammerite) can be used to top up this finish after this time frame if required.
Each gate has two vertical, four horizontal and four diagonal heavy duty braces on the back for maximum strength and durability. The overall height of the gates is 1800mm (71").
It is recommended that wooden gate posts are used when installing these gates. Optional smooth sawn pressure treated 15cm x 15cm square posts are available.
An optional galvanised fittings pack that includes a Ring Latch, 4 x 24 inch Hook and Band Hinges and an 18 inch drop bolt is also available.
The Windsor Estate Gates are available in the following sizes:
- 240cm Gate Width* x 180cm Gate Height - £599.95
- 270cm Gate Width* x 180cm Gate Height - £639.95
- 300cm Gate Width* x 180cm Gate Height - £679.95
- 330cm Gate Width* x 180cm Gate Height - £719.95
- 360cm Gate Width* x 180cm Gate Height - £759.95
*Please note that the Gate Width refers to the total width of the pair of gates, not each gate.
70mm x 70mm
70mm x 54mm & 44mm x 44mm
TONGUE & GROOVE
95mm x 14mm
Mortise & Tenon
Zinc plated and black powder coated
See size chart below to calculate how much space you will require to install your gate when using our 15cm x 15cm gate posts.
Pair of Posts
Total Gap Required
Information about your gate
Fittings - The Windsor gates are not supplied with any fittings; however an optional fittings pack is available which includes a drop bolt and the correct size hinges and latch for this weight of gate. The fittings we have available are galvanised to prevent rust. The gate has four horizontal braces on the back. Hinges should be fitted to the second and fourth brace.
Wooden Posts - Posts should be dug in approximately 60cm deep and held in place with concrete, or bolted to the wall using masonry bolts or frame fixing screws. A small gap must be left between the post and the gate to allow for expansion of the wood.
Finish - The Windsor gates are supplied pressure treated which leaves the wood with a temporary green tint. If left to weather, the wood will fade to a silvery grey colour; however you can change the colour by painting or staining the wood after it has been allowed to weather for at least 2 months. If you wish to do this, you should use a paint or stain that is compatible with pressure treated timber. The metalwork is supplied zinc plated and black powder coated so it will not need maintaining for approx. 5-10 years but can be topped up with a suitable exterior metal paint such as Hammerite if required.
|Direct from the factory in 3 to 4 weeks|
|Delivery charges apply to Highlands & Islands.|
Surcharge applies for Highlands and Islands