Using Store as ADMIN

Kensington Single Gate

  • Kensington Single Gate
  • Brand: BIC
  • Product Code: BIC750
  • SKU:
  • Availability: In Stock
  • £139.95

  • Free Delivery*


The Kensington Single Gate is a beautifully crafted gate that combines wood and metal to create a strong yet elegant gate that would complement even the most stately homes. The gate is hand made in the UK and features an open top section that is filled with vertical metal rods, with attractive ball finials running across the top of the gate. The lower section is solid tongue and groove, framed on both sides and across the top. The timber is smooth planed Scandinavian Redwood which has been pressure treated for along, maintenance free life. The gate has two vertical, three horizontal and one diagonal heavy duty brace on the back for maximum strength and durability. The overall height of the gate is 1200mm (47¼”).

It is recommended that wooden gate posts are used when installing these gates. Optional smooth sawn pressure treated 10cm x 10cm square posts are available.

An optional galvanised fittings pack that includes a Ring Latch, 2 x 18 inch Hook and Band Hinges.

The Kensington SingleGate is available in the following sizes:

  • 75cm Gate Width x 120cm Gate Height - £139.95
  • 90cm Gate Width x 120cm Gate Height - £159.95
  • 105cm Gate Width x 120cm Gate Height - £179.95

If our standard sizes won't fit, a made to measure service is available for this gate. Please click the tab below to be directed to the made to measure page.

View Made to Measure



70mm x 70mm


70mm x 56mm & 44mm x 44mm


95mm x 14mm


16mm Diameter - 40 mm Ball Top


Mortise & Tenon


Pressure Treated


Zinc Plated & Black Powder Coated


See size chart below to calculate how much space you willrequire to install your gate when using our 10cm x 10cm concrete in posts.

Gate Width

Expansion Gap

Pair of Posts

Total Gap Required













Information about your gate

Fittings. The Kensington gates are not supplied with any fittings; however an optional fittings pack is available which includes the correct size hinges and latch for this weight of gate. The fittings we have available are galvanised to prevent rust. The gate has three horizontal braces on the back. Hinges should be fitted to the top and bottom brace.

Wooden Posts. Posts should be dug in approximately 60cm deep and held in place with concrete, or bolted to the wall using masonry bolts or frame fixing screws. A small gap must be left between the post and the gate to allow for expansion of the wood.

Finish. The Kensington gates are supplied pressure treated which leaves the wood with a temporary green tint. If left to weather,the wood will fade to a silvery grey colour; however you can change the colour by painting or staining the wood after it has been allowed to weather for at least 2 months. If you wish to do this, you should use a paint or stain that is compatible with pressure treated timber. The metalwork is supplied zinc plated and black powder coated so it will not need maintaining for approx. 5-10 years but can be topped up with a suitable exterior metal paint such as Hammerite if required.

 Direct from the factory in 3 to 4 weeks
 Delivery charges apply to Highlands & Islands.

 Surcharge applies for Highlands and Islands

Write a review

Note: HTML is not translated!
    Bad           Good
The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.

Add GardenOasis App. Press Then select "Add to Home Screen"