The Corfe Single Gate is made from the finest materials to ensure the very best quality. This high quality gate is made with a chunky box frame giving it a heavyweight gate appearance with an authentic wrought iron finish. The elegant design will compliment the most stately building.
|
FRAME |
25mm x 25mm |
|
INFILL BARS |
16mm Diameter |
|
OPENING DIRECTION |
Right Hand Opening |
|
PADLOCKABLE |
No |
|
HINGES/LATCH/FITTINGS |
Included |
|
WIDTH TOLERANCE |
+50mm / -10mm |
|
FINISH |
Black primed |
Available in the following options:
-
2ft 6in - Fits gap width 76.2cm (2'6") - Gate height 116.8cm (46") - £179.95
-
3ft 0in - Fits gap width 91.4cm (3'0") - Gate height 116.8cm (46") - £189.95
-
3ft 3in - Fits gap width 99.1cm (3'3") - Gate height 116.8cm (46") - £199.95
-
3ft 6in - Fits gap width 106.7cm (3'6") - Gate height 116.8cm (46") - £209.95
Gate posts also available for £39 each - Size 70mm (3") square
How to Measure Gates
For the width, measure the gap you have between your walls or posts. If you are replacing an existing gate, do not measure the gate itself as this will not take into account the space for the hinges and latch that are supplied with your gate.
For example, if the measurement between your walls is 3ft. You should order the 3ft gate. If you also require posts, the space taken by the posts will be in additional to the gap required for the gate, so a 3ft gate and 2 x 3in posts will require a total opening of 3ft 6in.
The height measurement of the gate is from the bottom frame to the highest point in the gate.
When installing your gate, remember to allow for ground clearance, typically 50mm (2") or more if your ground slopes.
General Information
Fittings. The Corfe Single Gate is supplied with hinges, latch and striker plate. Self tapping screws are also included.
Opening Direction. The Corfe Single Gate is designed to be hinged on the left side as you look toward the house from the road and opening with your right hand, swinging away from the road.
Square Steel Posts. If you are installing directly onto brickwork, due to the weight of the gates, care should be taken to ensure the brickwork is strong enough to support them. Steel posts which are concreted into the ground are recommended to avoid damage to brickwork. Please note that the hinges require a flat vertical surface for installation.
Finish. The Corfe Single Gate is supplied dipped in a black primer ready for you to paint with a top coat in the colour of your choice. We recommend Hammerite but any exterior metal paint can be applied.
