2" (50mm) Square Metal Fence Post for use with Court Fence Panels. These posts are only compatible with our standard size panels or made to measure panels made to the standard height of 37in (950mm). If you are ordering made to measure panels with a different height, please order made to measure posts.

Available in the following options:

• 2" Concrete-In Post - 50mm x 1400mm
• 2" Bolt-Down Post - 50mm x 960mm

The posts are blank, giving you flexibility on the positioning of your fittings, allowing the post to be used as corner, end or in-line posts. The posts are supplied with self-drilling TEK screws that allow you to attach your fittings to the posts in the required position without needing to pre-drill holes, this makes it much easier to install on ground that slopes. The posts are zinc plated to prevent rust and have a black powder coated finish.

Should you wish to hang the fence panels on our fence posts, be sure to allow for the post widths. Eg. a 6ft fence panel and two 50mm (2") posts will fit a 6ft 4in gap.

Please ensure that the bolt down railing or fence posts are installed so the bolt down footplate runs at a 90o angle to the railing.

Finish

The steel is electro-galvanised to add a thin layer of zinc on the steel to prevent rust. The post is then powder coated in a black paint to give a smooth satin finish. This allows the post to be installed straight away and will be maintenance free for 5 to 10 years. Once rust starts to show, the post should be painted with a suitable exterior metal paint such as Hammerite.