The Sandringham Double Gates are made from solid steel for a traditional wrought iron appearance. The design incorporates hoops and spears to create an elegant yet stately driveway gate that will compliment town or country homes. These gates can also be padlocked for security.
|
SIDE FRAME |
25mm x 25mm |
|
TOP / BOTTOM FRAME |
25mm x 10mm |
|
INFILL BARS |
12mm Diameter |
|
OPENING DIRECTION |
Universal |
|
PADLOCKABLE |
Yes |
|
HINGES/LATCH/FITTINGS |
Included |
|
WIDTH TOLERANCE |
+50mm / -10mm |
|
FINISH |
Black primed |
Available in the following options:
-
8ft - Fits opening 243.8cm (8') - Height 116.8cm (46") - £479.95
-
9ft - Fits opening 274.3cm (9') - Height 116.8cm (46") - £549.95
-
10ft - Fits opening 304.8cm (10') - Height 116.8cm (46") - £609.95
-
11ft - Fits opening 335.3cm (11') - Height 116.8cm (46") - £669.95
-
12ft - Fits opening 3658cm (12') - Height 116.8cm (46") - £729.95
Gate posts available for £59 - Size 10cm (4") square
How to Measure Gates
For the width, measure the gap you have between your walls or posts. If you are replacing an existing gate, do not measure the gate itself as this will not take into account the space for the hinges that are supplied with your gate.
For example, if the measurement between your walls is 10ft. You should order the 10ft gate. If you also require posts, the space taken by the posts will be in additional to the gap required for the gate, so a 10ft gate and 2 x 4in posts will require a total opening of 10ft 8in.
The height measurement of the gate is from the bottom frame to the highest point on the gate.
When installing your gate, remember to allow for ground clearance, typically 50mm (2") or more if your ground slopes.#
If our standard sizes will not fit, a made to measure service is available for this gate. Click the button below to be redirected to the made to measure page.
General Information
Fittings. The Sandringham Double Gates are supplied with hinges, latch and two drop bolts.
Opening Directions. The Sandringham Double Gates can open in both directions. The latch is fitted to the right gate when viewed from the road.
Square Steel Posts. If you are installing directly onto brickwork, due to the weight of the gates, care should be taken to ensure the brickwork is strong enough to support them. Steel posts which are concreted into the ground are recommended to avoid damage to brickwork. Please note that the hinge plates require a flat vertical surface for installation.
Finish. The Sandringham Double Gates are supplied dipped in a black primer ready for you to paint with a top coat in the colour of your choice. We recommend Hammerite but any exterior metal paint can be applied.
