Hampton Driveway Gates

The Hampton Driveway Gates are both elegant and robust thanks to the combined use of quality smooth planed timber and metal rods and spear finials. The timber is Scandinavian Redwood which has been pressure treated for a long maintenance free life and the metalwork is steel that is dipped in black primer ready for you to paint in the colour and finish of your choice.

Wooden gate posts are recommended when installing these gate. Matching smooth planed 15cm x 15cm x 165cm concrete in pressure treated posts are available for £30 per post

A fittings pack is available for these gates for £59.95 which includes a Ring Latch Set and 4 x Hinges Bands, 4 x Screw-On Hinge Plates and an 18" drop bolt set.

The Hampton Driveway Gates are available in the following sizes:

• 240cm Gate Width x 120cm Gate Height - £379.95
• 270cm Gate Width x 120cm Gate Height - £429.95
• 300cm Gate Width x 120cm Gate Height - £479.95
• 360cm Gate Width x 120cm Gate Height - £579.95

If our standard sizes won't fit, a made to measure service is available for this gate. Please click the tab below to be directed to the made to measure page.

Specification

FRAME & STILES	70mm x 70mm
TONGUE & GROOVE	95mm x 14mm
INFILL BARS	12mm Diameter
JOINTS	Mortise & Tenon
FINISH	Pressure Treated Timber / Primed Metal

See size chart below to calculate how much space you will require to install your gate when using our 15cm x 15cm posts.

Gate Width	Expansion Gap	Pair of Posts	Total Gap Required
240cm	2cm	30cm (15cm x 2)	272cm
270cm	2cm	30cm (15cm x 2)	302cm
300cm	2cm	30cm (15cm x 2)	332cm
360cm	2cm	30cm (15cm x 2)	392cm

Information about your gate

Fittings. The Hampton gates are supplied without fittings unless you select the optional fittings pack which includes a ring latch, hinges and a drop bolt.

Wooden Posts. Concrete in posts must be dug in approximately 40cm deep. A small gap much be left between the post and the gate to allow for expansion of the wood.

Finish. The Hampton gates are supplied pressure treated which leaves them with a slightly green finish which if left untreated will fade or provides an ideal base for you to stain the timber in a colour of your choice. The metal infill bars and spear finials are dipped in back primer and will require a top coat of suitable exterior metal paint, such as hammerite, to prevent the formation of rust.